R-1501B Ammonia

K-1510B Ammonia VACUettes Kit was designed to obtain Ammonia levels from 0-120 ppm and 120-1200 ppm

Ammonia Information

$34.00

The K-1510B Ammonia Kit was designed to accurately measure the levels of Ammonia in water from 0-120 ppm and 120-1200 ppm. K-1510 B uses the Direct Nesserlization Method. The test kits employing the well-established Nessler reagent* to determine ammonia concentrations are applicable to drinking water, clean surface water, good-quality nitrified wastewater effluent, and seawater. In some waters, calcium and magnesium concentrations can cause cloudiness of the reagent. Adding a few drops of stabilizer solution (Rochelle Salt) will prevent this cloudiness. References recommend distilling samples prior to analysis. Results are expressed as ppm (mg/L) ammonia-nitrogen, NH3-N.

Shelf-life: although the Nessler reagent is stable, its high alkali content attacks the glass ampoule. The resulting precipitate interferes with color comparison. We recommend stocking quantities of CHEMets® and VACUettes® ampoules that will be used within five months. A two-month supply of Vacu-vials ampoules is suggested. Refrigeration will dramatically extend the shelf-life of these products.

 

*Contains mercury. Dispose according to local, state or federal laws.

R-1501 B Refill Package includes 30 tests and can be purchased separately.

What's included:

  • 30 Ampoules
  • Comparators (Low and High Range)
  • Dilutor Snapper Cup
  • Micro-Test Tube
  • Instruction Manual

  

 

How to use:

  1. Fill the micro-test tube halfway with water sample
  2. Fill to the dilutor snapper cup to the specific mark with distilled water.Fill the sample cup to 25ml 


  3. Ensure the VACUette tip is firmly attached to ampoule tip. Holding the VACUette horizontally, touch the tip to the contents of the micro-test tube.
  4. Place the VACUette between the vertical tip guides on the inside of the dilutor snapper cup. Snap the ampoule tip.
  5. Mix ampoule by inverting several timesTip the vacu-vial back and forth to mix
  6. Dry the ampoule, and wait 1 minute for color development.
    Dry vacu-vial and then insert into the I-2019
  7. Obtain results by placing ampoule between color standards until best color match is found. 

Downloads:

K-1510A-D Instructions

Ammonia Tech Sheet

Ammonia Information

P6510

WARNING! This product can expose you to chemicals including mercury, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

More Information
Manufacturer CHEMetrics
Call For Price No
Gas Ammonia (NH3)
4-20 mA Output No
Voltage Output None
Power Requirements 4 AAA Batteries
Datalogging No
Warranty 1 Year
Write Your Own Review
You're reviewing:R-1501B Ammonia
Your Rating
We found other products you might like!
Loading...