K-2810 Chromate

K-2810 Chromate Kit was designed to obtain Chromate levels from 0-1 ppm and 1-10 ppm

Replacement ampoules for the K-2810Test Kit can be found here.

Chromate Information

$69.00

Why Choose CHEMetrics Chemets kits?

CHEMetrics Chemets self-filing reagent ampoules are a great way to test for dissolved substances in liquids. These visual test kits allow you to obtain results by measuring the color of the sample according to the color comparators provided with the kit. This unique method allows you to attain results quickly and accurately with minimal contact with potentially hazardous materials.

Safe and Reliable Results

While traditional methods often require multiple steps and thorough preparation, these test kits allow you to obtain dependable results with a few simple steps. By simplifying the testing method, Chemets test kits reduce the potential for operator error. Additionally, each of the ampoules contained in the test kits is vacuum sealed which helps eliminate the problem of obtaining inaccurate results from stale or unstable reagents. These reagents are stored right in the tip of each ampoule and sealed in glass, thereby minimizing direct contact with the chemicals.

What's included:

  • 30 self-filling Ampoules
  • low and high-range comparators 
  • 1 25 mL Sample Cup
  • Acidifier Solution
  • 1 mL syringe
  • Instruction Manual
 

Method

The K-2810 Chromate Kit was designed to accurately measure the levels of Chromate in water from 0-1 ppm and 1-10 ppm. K-2810 uses the Diphenylcarbazide Method. With the chromate test method, hexavalent chromium reacts with diphenylcarbazide under acid conditions to form a red-violet color. Results are expressed as ppm (mg/L) CrO4

 

1. Fill the sample cup to the 20 mL mark with the sample to be tested. Add 4 drops of Acidifier Solution. Stir to mix the contents of the cup. 2. Place the Vacu-vial ampoule tip-first into the sample cup. Snap the tip and the ampoule will automatically fill.
3. To mix the ampoule, tilt it from side to side, allowing the bubble to travel from end to end. 4. Dry the ampoule and wait 2 minutes for color development.
5. Place the ampoule into the center of the round comparator and hold it toward a source of light, viewing from the bottom. Rotate the comparator until the color below the ampoule shows the closest match. 6. For higher concentrations, use flat comparator. Place the ampoule between the color standards, moving it along the comparator until you can determine the closest match.

For more detailed instructions, see the link at the bottom of the page.

P6508

WARNING! This product can expose you to chemicals including mercury, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

 

More CHEMetrics Kits for Ammonia

Vacu-Vials
Product Number Method   Range Price
K2803 Diphenylcarbazide   0-3.5 ppm $30.00
Chemets Kits
Product Number Method MDL Range Price
K2810 Direct Nesslerization 0.05ppm 0-1 & 1-10ppm $66.00

 

Downloads:

K-2810 Instructions

Chromate Tech Sheet

Chromate Information

More Information
Manufacturer CHEMetrics
Call For Price No
Gas Chromate
4-20 mA Output No
Voltage Output None
Power Requirements 4 AAA Batteries
Datalogging No
Warranty 1 Year
Write Your Own Review
You're reviewing:K-2810 Chromate
Your Rating
We found other products you might like!
Loading...