Ammonia (NH3) sensor head with Gas Sensitive Semiconductor (GSS) technology that will measure Ammonia from 0-1000 ppm with a 1.0 ppm resolution providing a <±15 ppm accuracy.

Detailed info sheet on Aeroqual Ammonia Sensor

Full list of technical information and specifications for all Aeroqual sensors

Ammonia Information

This head uses an active sensor technology with an internal fan to pull air accross the GSE sensor at a specific flow rate for accurate gas detection.  The fan will pull a fresh gas stream across the GSE sensor every 120 seconds for accurate Ammonia detection.

This sensor head will be a direct fit onto any Series-300, Series-500 or Ranger Aeroqual ozone monitor.  This head can be purchased as an addition to your existing monitor, or with a new base unit.  To purchase with a base unit see our Aeroqual ozone monitor page.  If you currently have an Aeroqual ozone monitor this sensor will be a direct fit for your current monitor.  The Series-300, Series-500 or Ranger will automatically detect this as a 0-100 ppm Ammonia head and react accordingly.

Detailed Sensor Specifications for Aeroqual ambient sensors

Click on image to expand

Calibration:

This sensor is a Gas Sensitive Electrochemical (GSE) sensor. The Aeroqual ENG sensor has a detection range of 0-1000 ppm, so the calibration gas you use must fall within this range. Refer to the table below for our recommended calibration gas options.

Ammonia Calibration Gas

Link copied: https://www.gas-sensing.com/aeroqual-ammonia-sensor-0-1000-ppm-nh.html#ammonia-calibration-gas

Product	Range	Price
Ammonia Calibration Kit	25 ppm, 50 ppm, 100 ppm, 250 ppm, 300 ppm	$572.00

Ammonia Calibration Kit

$572.00

Range

25 ppm, 50 ppm, 100 ppm, 250 ppm, 300 ppm

View Details

Sensor Type:

There are two types of Aeroqual sensors, type 1 and type 2. 
The type 1 is used with the S-200, S-300, S-500, Ranger and S-900 monitors.
The type 2 is calibrated specifically with fittings on the end allowing it to be used with the ENC enclosure and in the S930

Full list of technical information and specifications for all Aeroqual sensors

Ammonia Information

All sensors require a yearly calibration to ensure your gas measurements are accurate and performing within manufacturer standards. This page is desiccated to the individual manufacturers we represent and their specific calibration procedures. 

**Calibration Service Request Form **